Decastrip Max
- Paint stripper, removes layers of paint from wood, stone, metal, etc.
- It enables you to strip away coats of paint made from a wide range of ingredients, such as latex, acrylate, oil, cellulose, alkyd, chlorinated rubber, polyurethane, epoxy, …
- Can also be used for removing adhesives, tags and graffiti.
- Not suitable for mineral paints for example such as lime paint.
- Ready to use.
- Made from a blend of solvents and softening agents.
- Thixotropic: applies perfectly on vertical surfaces.
- Rapid action.
- Free of methylene.
- Does not contain any alkalis, acids or phenols.
- Efficient, lower consumption.
Technical specifications
| Processing: | - Apply non-diluated by using an airless, a brush, a brush or a roller. - Allow to soak in until the (paint) layers begin to swell and dissolve. This can take between 5 up to 30 minutes. Apply on a test patch in advance to evaluate the effect and speed. - Remove the layers with a scraper or with water under high pressure. - Use steam cleaning if necessary for paint layers that are difficult to remove. - In certain cases (e.g. several paint layers), application of an additional layer may be required. - Rinse the substrate very well afterwards to ensure that it is perfectly clean and that all residue of Decastrip Max is removed. - Certain types of paint may require a longer contact time. To prevent the product from drying out, it is covered with a plastic film in case of longer contact times (up to 2 hours). |
| Consumption: | 0,2 – 0,5 ltr/m² |
| Packaging: | 1ltr, 2,5 ltr, 20 ltr |